hp laserjet 2100 driver for mac os 10.12

Using my Mac's Network Utility, I pinged this address, which came back showing nothing. This time, it reported an IP address of 192.0.0.192.

The first attempt showed no IP address, so I gave it a bit more time and tried again. I turned the printer off and back on, waited a minute or two, and printed a test page by simultaneously holding down the Job Cancel and Go buttons. Once the 600N arrived, I installed it in the printer and connected it to my AirPort Extreme. This is where most of the week of setup time was spent. I also found that the HP JetDirect 600N card was compatible with this printer, ordered one from Amazon, and also found out how to print a test page with the printer's IP address. So, taking back to Google, I read about setting the 2100 up as an IP printer. When first connecting the parallel end of the Parallel to USB cable to the printer, I noticed there was room to put a network card in the printer. Incidentally, I had to delete and re-add the printer no matter if I was using the HP driver or the Gutenprint driver. Once these drivers were installed, the garbled text issue was resolved, but I now noticed something new - every time I rebooted, I would have to delete the printer and add it again, and this got old very quickly. Taking to Google, I found others having the same problem and resolved it using Gutenprint drivers. However, this only worked for a short while before the printer began spitting out gibberish. The connection was successful and Software Update found the proper drivers and installed them. The first thing I tried was using a Parallel to USB cable and hooking the printer directly up to one of the USB ports on my system. However, the entire process took around a week, so hopefully this will help others see just how easy it is to use this printer with a Mac running El Capitan.

Earlier today, I was able to successfully set up an HP LaserJet 2100 on my 2009 Mac Pro.

Hp laserjet 2100 driver for mac os 10.12